Re: [Testbed-admins] Is there any one successfully utilized Cisco 2960 switch with Emulab software?

[Robert P Ricci <ricci@cs.utah.edu>]

That list is out of date, we do have someone (I forget who...) who runs
on 2960s.

Thus spake chunhui Zhang(Evan) on Tue, Oct 06, 2009 at 12:58:30PM -0400:
> Hi,
> 
>     We are trying to buy a Emulab supported Cisco switch here. We looked at
> the 2950 first, but this switch just have two ports with gigbit capbility
> which is not satisfiable.
> 
> And the Model 2960 could have more gigabit ports. However, this model is not
> in list here.
> http://users.emulab.net/trac/emulab/wiki/install/prerequisites.html
> 
> A little bit worried about this switch and want to make sure whether this
> model will work or highly possible will work.
> 
> Thank you very much!
> 
> Chunhui Zhang (Evan)
> GENI Intern at BBN

> _______________________________________________
> Testbed-admins mailing list
> Testbed-admins@flux.utah.edu
> http://www.flux.utah.edu/mailman/listinfo/testbed-admins


-- 
/-----------------------------------------------------------
| Robert P Ricci <ricci@cs.utah.edu> | <ricci@flux.utah.edu>
| Research Associate, University of Utah Flux Group
| www.flux.utah.edu | www.emulab.net
\-----------------------------------------------------------